We assume that you have visited and completed both tutorials listed above. Now, we need to execute a couple steps before connecting your OMAP DSP to your computer. We recommend you to follow the steps below:
- Verify that all development board DIP switches (two packages of eight switches, each) are in the “OFF” position. If you look closely, the switch positions are labeled.
- Power on the board, connecting the power supply to the 5 V barril (power connector), and turning on the board using the large black slide switch. Three LEDs should now be energized on the development board.
- Start up and allow the computer that you installed CCS on to fully finish its boot-up process. Plug the USB cable into the development board and then plug the other end of the cable into your PC. Be sure that you allow the computer to finish loading the device drivers before you move to the next step.
- Launch CCS by double clicking on its icon. After a standard CCS install, this icon will be located on your computer’s “desktop”. You are looking for the icon shown below.
Now you have your board set up and ready to run your first code! When the CCS software initialize, you should be able to see a window similar to the one below:
Important Note: As part of this project, code will be generated and compiled in a nice final folder. All of the codes regarding our work with Biomedical Signal Processing (i.e. the processing and analysis of digitalized biosignals) will be posted in this webpage shortly. At this point, we will keep providing tutorials on the code and examples listed in our text book. This way, you will be familiar with the board and its applications before starting with the analysis of biosignals. For this reason, all the files needed to run and implement the example codes on our text book can be found the the CD that comes with the book.
As explained in the Getting Started with the OMAP L-138 tutorial, we assume that you followed the instructions and have already installed the software that was included on the provided CD- ROM.
- In your computer, use Windows Explorer to verify that the directory common_code exists at C:CDcodecommon_code (please keep in mind that C:CD may be some other name or disk location that you specified when you installed the provided software). If this directory structure does not exist, you either need to create it or install the provided software. There should be several files in the common_code directory. If these files are not already in the directory, they can be copied from the common_code directory of the provided CD-ROM.
- Some form of organization is required for your projects and the dozens of files you will eventually create. CCS uses the concept of a workspace to organize groups of projects. A single workspace can be used to manage any number of projects.
- If you copied the files from a CD-ROM, the files most likely have a “read-only” attribute. Removing this attribute may prove helpful later in this process.